Removing The Fixing Roller, Insulating Bush And Thrust Stopper - Canon imageRUNNER ADVANCE 6075 Series Service Manual

4
Parts Replacement and Clearning > Fixing > Removing the Fixing Roller, Insulating Bush and Thrust Stopper
CAUTION: Points to Caution at Installation of the Fixing Drive Unit 2
• Be sure to fit the protrusion of the Fixing Shutter to the groove of the Fixing Shutter
Drive Gear (Front) to install.
• Remove the Fixing Pin for the Shutter Drive Gear (Front) and return to the original
position. (Refer to "Separating the Fixing Upper Unit from the Fixing Lower Unit")
4 Parts Replacement and Clearning > Fixing > Removing the Fixing Roller, Insulating Bush and Thrust Stopper
Removing the Fixing Roller, Insulating Bush and Thrust
Stopper
<Preparation>
1. Pull out the Fixing Feed Unit. (Refer to "Removing the Fixing Assembly")
2. Remove the Fixing Assembly. (Refer to page 4-176)
3. Remove the Fixing Front Cover. (Refer to "Removing the Fixing Cleaning Web")
4. Remove the Fixing Drive Unit 1. (Refer to "Separating the Fixing Upper Unit from the Fixing
Lower Unit")
5. Secure the Shutter Drive Gear. (Refer to "Separating the Fixing Upper Unit from the Fixing
Lower Unit")
6. Separate the Fixing Upper Unit from the Fixing Lower Unit. (Refer to "Separating the Fixing
Upper Unit from the Fixing Lower Unit")
7. Remove the Heater Unit.
7-1) Remove the Heater Unit.
• 4 Screws
F-4-336
x4
CAUTION: Points to Caution at Installation of the Heater Unit
Remove the Fixing Pin for the Shutter Drive Gear (Rear) and return to the original
position. (Refer to "Separating the Fixing Upper Unit from the Fixing Lower Unit")
4-186
F-4-337
4-186