How To Cancel Meap Safe Mode; Setting Http Port For Meap Application (Level 2); Outline - Canon imageRUNNER ADVANCE 6075 Series Service Manual

2
Technology > MEAP > Setting HTTP port for MEAP application (level 2) > Outline

■ How to cancel MEAP SAFE mode

If you want to end safe mode, repeat the steps but change '1' to '0' in step -4 and restart the
device.
Note:
If accessed to SMS in MEAP SAFE mode, the device started mode is shown on the title
bar of the browser.
When normally started:
Service Management Service : <Device Name>: <Product Name>
When starting in MEAP SAFE mode:
Service Management Service : <Device Name>:<Product Name>: Safe Mode
2 Technology > MEAP > Setting HTTP port for MEAP application (level 2) > Outline

Setting HTTP port for MEAP application (level 2)

■ Outline

For the ports in which the MEAP application uses, the default is 8000 for the port on HTTP
server, and 8443 for the port on HTTPS server. In the case that these ports have already
used by the customer who is to introduce this application, the MEAP application cannot use
the HTTP (or HTTPS) server(s).
By changing the following ports to use, however, the MEAP application can be used as well
as the existing system.
● HTTP server
Setting value is 0 through 65535 [the value at factory shipment/after clearing RAM: 8000]
Note:
Do not use port number "8080" when PS print server unit is connected. If the port
is used, you can not see the page for RUI of the device with MEAP authentication
application. (port "8080" is reserved for redirecting from PS print server unit to device.)
● HTTPS server
Setting value is 0 through 65535 [the value at factory shipment/after clearing RAM: 8443]
Note:
As for port on HTTPS server, it only applies to the device that supports SSL function.
F-2-292
2-207
2-207