Canon imageRUNNER ADVANCE 6075 Series Service Manual page 434

4
Parts Replacement and Clearning > Image Formation System > Replacing the Pre-transfer Charging Wire
5) Hook the ring to the rear charging electrode of the Pre-charging Assembly and put the ring
through the rear groove and the sponge groove.
Charging Wire
6) On the front side of the Pre-charging Assembly, hook the Charging Wire Tension Spring to
the Charging Wire to twist with it.
7) Cut extra length of the Charging Wire with nippers.
4 Parts Replacement and Clearning > Image Formation System > Replacing the Pre-transfer Charging Wire
Groove
Charging
Electrode
F-4-131
F-4-132
8) Hold the tip of the Spring with tweezers and hook the Charging Wire to the groove to hook
the Spring to the Hook.
Hook
9) Clean the Charging Wire with lint-free paper moistened with alcohol.
10) Install the Pre-transfer Charging Assembly Covers (Front and Rear).
11) Install the Pre-transfer Charging Assembly Cleaner and the Pre-transfer Charging
Assembly Cleaner Holder.
<Processing when replacing the parts>
1) Clear the parts counter. (COPIER>COUNTER>PRDC-1>PO-WIRE)
2) Clean the Charging Wire. (COPIER>FUNCTION>CLEANING>WIRE-EX)
4-113
F-4-133
4-113