Turning Off The Main Power - Canon imageRUNNER ADVANCE 6075 Series Service Manual

Turning ON the Main Power
<In the Case of Copier Model>
1) Connect the power plug of the host machine to the power outlet.
2) Remove the protection sheet on the control panel.
3) Open the switch cover and turn ON the main power switch.
CAUTION:
If Color Image Reader Unit is installed, "E732-8888" is displayed after turning ON the
main power switch. If "E732-8888" is displayed, turn OFF and then ON the main power
switch. Then, perform the following steps.
4) Check that the value of the following service mode corresponds to the type of the installed
Image Reader Unit.
Service Mode > COPIER > OPTION > CUSTOM > SCANTYPE
Setting Value "0" Color Image Reader Unit
Setting Value "1" Duplex Color Image Reader Unit
5) Exit the Service Mode.
NOTE:
Be sure to perform the following procedure for operation check of the Stamp Unit.
To enable the Stamp Unit, it is required to install the FAX Board.
6) Change the operation panel screen to "Scan and Send", and press "Other Function".
7) Press "Finished Stamp" in the second page of the "Other Function" screen.
8) Set to the feeder and conduct transmission test to check that the originals are stamped.
<In the Case of Printer Model>
1) Connect the power plug of the host machine to the power outlet.
2) Remove the protection sheet on the control panel.
3) Open the switch cover and turn ON the main power switch.
4) A message is displayed prompting to check that the Reader Unit Cable is connected
properly.
5) Select the following service mode and enter "0" to the setting value.
COPIER > OPTION > FNC-SW > W/SCNR
6) Exit the Service Mode.
7) Turn OFF and then ON the main power switch.
9
Installation > Installation > Turning OFF the Main Power

Turning OFF the Main Power

1) Open the Switch Cover and turn OFF the main power switch.
2) Check that the control panel display and the main power lamp are OFF, and then
disconnect the power plug.
9 Installation > Installation > Turning OFF the Main Power
9-21
9-21