Removing The Left Deck Pickup Drive Unit - Canon imageRUNNER ADVANCE 6075 Series Service Manual

4
Parts Replacement and Clearning > Pickup/Feed System > Removing the Left Deck Pickup Drive Unit
NOTE:
When installing the Registration Unit, be sure to follow the order as shown in the figure
to tighten screws.
x4
4 Parts Replacement and Clearning > Pickup/Feed System > Removing the Left Deck Pickup Drive Unit

Removing the Left Deck Pickup Drive Unit

<Preparation>
1. Remove the Box Cover (Left). (Refer to "Removing the Vertical Path Cassette Pickup Drive
Unit")
2. Open the Controller Box. (Refer to "Removing the Vertical Path Cassette Pickup Drive
Unit")
3. Remove the Rear Lower Cover. (Refer to "Removing the Vertical Path Cassette Pickup
Drive Unit")
4. Remove the Power Supply Assembly.(Refer to page 4-234)
5. Remove the Left Deck Pickup Unit. (Refer to page 4-215)
<Procedure>
1) Remove the Left Deck Pickup Drive Unit in the direction of the arrow.
• 6 Screws
• 1 Connector
F-4-455
• 1 Wire Saddle
x6
4-224
F-4-456
4-224