Canon imageRUNNER ADVANCE 6075 Series Service Manual page 457

4
Parts Replacement and Clearning > Image Formation System > Removing the Developing Cylinder and the Developing Roller
CAUTION: How to Install the C Ring
When installing the C Rings removed in step 2 and 3, be sure to perform the following
to fit the C Rings into the groove of the Developing Cylinder securely.
1. Fit the C Ring into the groove of the Developing Cylinder Shaft using a dedicated
tool.
2. Locate the side of the Gear where the Parallel Pin removed in step 2 was set inside,
and install the Gear to the Developing Cylinder Shaft temporarily.
3. Insert the Gear while pushing it against the C Ring, and check that click sound
which occurs when the C Ring fits into the groove of the Developing Cylinder Shaft
is heard.
4. Pull out the Gear from the Developing Cylinder Shaft, and check visually that the C
Ring is fitted into the groove of the shaft.
4 Parts Replacement and Clearning > Image Formation System > Removing the Developing Cylinder and the Developing Roller
3) Remove the Bearing to remove the Developing Cylinder.
Bearing
F-4-186
F-4-187
4-136
Bearing
F-4-188
4-136