10) Open the Controller Box, and disconnect the Signal Cable and the Power Supply Cable
on the host machine. (Disconnected cables will not be used.)
• 2 Connectors
• 9 Wire Saddles
• 2 Edge Saddles
x2
x11
9
Installation > [TYPE-3] Option HDD (250GB) + Removable HDD Kit > Installation Procedure > Changing Configuration inside of HDD Case Unit
11) Remove the HDD Case Unit.
• 2 Screws (The removed screws will be used in "Installing the HDD Case Unit" step 1).)
■ Changing Configuration inside of HDD Case Unit
1) Remove the E-ring from the removed HDD Case Unit, remove the shaft of the HDD Cap,
and then remove the HDD Fixed Plate. (The removed HDD Fixed Plate will not be used.)
F-9-320
2) Put the HDD Cap and the shaft back to the HDD Case Unit, and secure the HDD Case Unit
with the E-ring.
9
Installation > [TYPE-3] Option HDD (250GB) + Removable HDD Kit > Installation Procedure > Changing Configuration inside of HDD Case Unit
x2
F-9-321
HDD Fixed Plate
F-9-322
9-142
9-142