Controller System; Hdd - Canon imageRUNNER ADVANCE 6075 Series Service Manual

5
Adjustment > When replacing parts > Controller System > HDD
Overview
In this chapter, measures of adjustment when replacing parts in servicing operation are
mentioned. Parts to be replaced are categorized into 4 blocks based on their related
technology as shown below.
Parts Name Actions at Parts Replacement

Controller System

HDD

Main Controller PCB1
Main Controller PCB2
TPM PCB
Image Formation System Primary Charging Wire
Primary Charging Assembly
Pre-Transfer Charging Assembly
Pre-Transfer Charging Wire
Drum
Drum Side Seals (Front and Rear)
Developing Assembly
Potential Sensor / Potential Control PCB
ETB
Waste Toner Container
Fixing System Fixing Roller
External Auxiliary System DC Controller PCB
5 Adjustment > When replacing parts > Controller System > HDD
When replacing parts
Controller System
■ HDD
<Procedure of parts replacement>
p. 5-2
Refer to Removing HDD
p. 5-4
p. 5-5
<Procedure of adjustment>
p. 5-7
1. Before Replacing
p. 5-7
Perform the following operations. Be sure to get an approval from the user beforehand.
p. 5-7
1) Backup of the set/registered data
p. 5-9
Use the Remote UI.
p. 5-9
p. 5-10
Management Settings > Data Management > Import/Export
p. 5-11
Target data:
p. 5-11
• Address List
p. 5-11
• Forwarding Settings
p. 5-11
• Settings/Registration
p. 5-11
p. 5-12
• Web Access Favorites
p. 5-12
• Printer Settings
T-5-1
• Paper Information
2) Printing the set/registered data
Use the service mode.
(Lv.1) COPIER > FUNCTION > MISC-P > USER-PRT
List of the set/registered data which cannot be backed up is printed.
5-2
5-2