Steps To Service Browser Settings - Canon imageRUNNER ADVANCE 6075 Series Service Manual

2
Technology > Embedded RDS > E-RDS Setup > Steps to Service Browser settings
● Steps for settings of service call cancellation
1. Touch the [Counter Check] button on the control panel to display the counter check screen,
and touch the [Service Call] button.
2. Touch the [Cancel] button, and touch the [Yes] button in the check screen.
NOTE:
E-RDS generates an alarm of service call cancellation at this timing, and sends the
alarm to UGW.
2 Technology > Embedded RDS > E-RDS Setup > Steps to Service Browser settings

■ Steps to Service Browser settings

1. Start [Service Mode] at Level 1.
For the procedures, see "Steps to E-RDS settings - step 1.".
2. Select [COPIER] > [Function] > [INSTALL] > [BRWS-ACT] and then touch [OK].
NOTE:
E-RDS sends browser information to UGW at this timing.
F-2-338
If the connection is established with UGW successfully, "OK!" is displayed. When "NG!" is
displayed, perform the steps referring to "Troubleshooting" until connection is established
with UGW.
F-2-339
2-229
F-2-340
F-2-341
2-229