Canon imageRUNNER ADVANCE 6075 Series Service Manual page 1125

2) Connect the CH A Cable (FK2-7832) to the Main Controller PCB 2.
• 2 Connectors
• 1 Edge Saddle
• 4 Wire Saddles
NOTE:
Be sure not to close the 2 Wire Saddles [A] in this step.
x2
x5
CAUTION:
Check that the connector of the Signal Cable is connected properly and that the cable
is not overloaded.
9
Installation > [TYPE-2] Removable HDD Kit > Installation Procedure > Installing the HDD Case Unit
[A]
F-9-294
F-9-295
9 Installation > [TYPE-2] Removable HDD Kit > Installation Procedure > Installing the HDD Case Unit
3) Fold extra length of the CH B Cable (FK2-7837), and secure it with the 2 Wire Saddles.
CAUTION:
• Be sure that the cable is not in contact with the stepped screw [A] of Drawer.
• When securing the cable, be sure that it does not go over to the front.
• When the FAX Board is installed, be sure to avoid contact of the cable with the PCB
to secure the cable.
x2
[A]
4) Insert the assembled Removable HDD.
9-128
F-9-296
F-9-297
9-128