5
Adjustment > When replacing parts > Image Formation System > Waste Toner Container
■ Drum Side Seals (Front and Rear)
<Procedure of parts replacement>
see "Removing the Side Seal," on p. 4-128.
<Procedure of adjustment>
1) Applying Tospearl
Apply Tospearl on the surfaces of the Drum Side Seals (Front and Rear) and adhere it
uniformly with lint-free paper. In order to reduce adhesion of toner at both ends of the
Photosensitive Drum
Tospearl
Sheet
■ Developing Assembly, Developing Cylinder
<Procedure of parts replacement>
see "Removing the Developing Assembly," on p. 4-129.
<Procedure of adjustment>
1) Supplying Developing Assembly toner (COPIER>FUNCTION>INSTALL>TONER-S)
■ Potential Sensor / Potential Control PCB
<Procedure of parts replacement>
see "Removing the Potential Control PCB Unit," on p. 4-166.
<Procedure of adjustment>
1) Adjust the Potential Sensor offset.(COPIER > FUNCTION > DPC > OFST)
5
Adjustment > When replacing parts > Image Formation System > Waste Toner Container
■ ETB Unit / ETB
<Procedure of parts replacement>
• see "Removing the ETB Unit," on p. 4-137.
• see "Removing the ETB," on p. 4-139.
<Procedure of adjustment>
1) Clear the ETB control counter. (COPIER>FUNCTION>CLEAR>TR-BLT)
Parts counter (COPIER>COUNTER>DRBL-1>TR-BLT) is also cleared coincidentally.
■ Waste Toner Container
<Procedure of parts replacement>
see "Removing the Waste Toner Container," on p. 4-145.
<Procedure of adjustment>
1) Set the new Waste Toner Container.
2) Clear the waste toner counter. (COPIER>COUNTER>MISC>WST-TNR)
lint-free paper
F-5-9
5-11
5-11