Leading Edge Margin Adjustment (Multi-Purpose Tray Pickup); Checking The Network Connection; Overview - Canon imageRUNNER ADVANCE 6075 Series Service Manual

■ Leading Edge Margin Adjustment (Multi-purpose Tray Pickup)

NOTE:
By executing the leading edge margin adjustment for the Multi-purpose Tray Pickup, the
adjustment is applied to all source of paper.
Execute duplex printing from the Multi-purpose Tray Pickup, and check that the leading edge
margin is within L12.5 +/- 0.5mm.
If it is not within the range, execute adjustment by following the procedure below.
Feeding direction
of paper
1) Adjust the image position in service mode.
• COPIER > ADJUST > FEED-ADJ > RG-MF
As the value is incremented by 1, the leading edge margin is decreased by 0.1mm.
2) Execute duplex printing from the Cassette 3, and check that the leading edge margin is
within 2.5 +/- 0.5mm.
3) When the setting value was changed in step 1), write down the new numerical value in the
service label.
4) Exit from the service mode.
9
Installation > Installation > Checking the Network Connection > Checking the Network Connection
L1
image
F-9-63
9 Installation > Installation > Checking the Network Connection > Checking the Network Connection

Checking the Network Connection

■ Overview

If the user's network environment is TCP/IP, use the Ping function to check that the network
setting is properly performed.
If the user's network environment is IPX/SPX or Apple Talk, there is no need to check the
network environment.
■ Checking the Network Connection
CAUTION:
Be sure to use the network cable with Category 5e or higher. In addition, a sealed type
(STP cable) is recommended.
Using the non-shield type can affect the peripheral electrical equipment through the
network cable.
1) Turn OFF the main power switch.
2) Connect the network cable to the Host Machine and turn ON the main power switch.
3) Inform the system administrator at the installation site that installation of the Host Machine
is complete, and then, ask for the network setting.
NOTE:
Network setting cannot be executed unless logging in as an administrator.
Factory default password is as follows.
• System administration division ID: 7654321
• System administration password: 7654321
CAUTION:
To perform the network setting, the following Additional Functions items must be set
"ON".
• [Additional Functions] > [Configuration] > [Network] > [Change network settings/
check connection]
• [Additional Functions] > [Configuration] > [Network] > [TCP/IP Setting] > [IPv4
setting] > [Use IPv4]
4) Turn OFF and then ON the main power.
9-31
9-31