Installing The Hdd Case Unit - Canon imageRUNNER ADVANCE 6075 Series Service Manual

■ Installing the HDD Case Unit

1) Install the HDD Case Unit.
• 2 Hooks
• 2 Bosses
• 2 Screws (Use the screws removed in "Removing the HDD and HDD Case Unit" step 11).)
NOTE:
Be careful not to catch the plate of the host machine with the Wire Saddles on the rear
side of the HDD Case Unit, otherwise the installation work may become difficult.
x2
Hook
9
Installation > [TYPE-3] Option HDD (250GB) + Removable HDD Kit > Installation Procedure > Installing the HDD Case Unit
2) Connect the CH A Cable (FK2-7832) to the Main Controller PCB 2.
• 2 Connectors
• 1 Edge Saddle
• 4 Wire Saddles
NOTE:
Be sure not to close the 2 Wire Saddles [A] in this step.
Hook
Boss
CAUTION:
Check that the connector of the Signal Cable is connected properly and that the cable
is not overloaded.
F-9-327
9 Installation > [TYPE-3] Option HDD (250GB) + Removable HDD Kit > Installation Procedure > Installing the HDD Case Unit
x2
x5
[A]
9-144
F-9-328
F-9-329
9-144