NOTE:
Be sure to secure the extra slack of the Antenna Cable for MFP at the position
shown in the figure.
20)
Put the Antenna Cable for MFP through the Cord Guides, and install the Cord Guide
Covers.
9
Installation > Installation Procedure for Expansion Bus-F1/F2, IPSec Board-B2 and Wireless LAN Board-B1 > Checking after Installation
F-9-253
F-9-254
9
Installation > Installation Procedure for Expansion Bus-F1/F2, IPSec Board-B2 and Wireless LAN Board-B1 > Checking after Installation
21)
Affix the Wireless LAN Label.
Checking after Installation
In the Case that the IPSec Board is Installed:
1) Connect the power plug to the outlet.
2) Turn ON the main power switch.
3) Select [Settings/Registration] > [Preferences] > [Network] > [Confirm Network Connection
Set. Changes], and set the item "ON".
4) Select [Settings/Registration] > [Preferences] > [Network] > [TCP/IP Settings].
5) Check that "IPSec Settings" is displayed.
In the Case that the Wireless LAN Board is Installed:
1) Connect the power plug to the outlet.
2) Turn ON the main power switch.
3) Select [Settings/Registration] > [Preferences] > [External Interface].
4) Check that "Extension Card Settings" is displayed.
9-105
F-9-255
9-105