Host - Dell Z9500 Command Reference Manual

Version
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0

host

For manual (rather than automatic) configurations, assign a host to a single-address pool.
Z9500
Syntax
host address
Parameters
address/mask
Defaults none
Command DHCP <POOL>
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0
ip address dhcp
Configure an interface to receive its IP address from the configured DHCP server.
Z9500
Syntax
ip address dhcp
To release the IP address acquired from a DHCP server, enter the no ip address
dhcp command.
Dynamic Host Configuration Protocol (DHCP)
Description
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Enter the host IP address and subnet mask.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
711