Netbios-Node-Type - Dell Z9500 Command Reference Manual

netbios-node-type

Specify the NetBIOS node type for a Microsoft DHCP client. Dell Networking recommends specifying
clients as hybrid.
Z9500
Syntax
netbios-node-type type
Parameters
type
Defaults Hybrid
Command DHCP <POOL>
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0
network
Specify the range of addresses in an address pool.
Z9500
Syntax
network network /prefix-length
Parameters
network/
prefix-length
716
Enter the NETBIOS node type:
• Broadcast: Enter the keyword b-node.
• Hybrid: Enter the keyword h-node.
• Mixed: Enter the keyword m-node.
• Peer-to-peer: Enter the keyword p-node.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Specify a range of addresses. Prefix-length range is from 17
to 31.
Dynamic Host Configuration Protocol (DHCP)