Disable - Dell Z9500 Command Reference Manual

disable

Disable the DHCP server.
Z9500
Syntax
disable
DHCP Server is disabled by default. To enable the system to be a DHCP server, use
the no disable command.
Defaults Disabled
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0
dns-server
Assign a DNS server to clients based on address pool.
Z9500
Syntax
dns-server address [address2...address8]
Parameters
address
Defaults none
Command DHCP <POOL>
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
708
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Enter a list of DNS servers that may service clients on the
subnet. You may list up to eight servers, in order of
preference.
Dynamic Host Configuration Protocol (DHCP)