Debug Ipv6 Dhcp - Dell Z9500 Command Reference Manual

Version
8.3.19.0
8.3.11.1
8.3.7.0
8.3.1.0
8.2.1.0
Related show ip dhcp snooping
Commands

debug ipv6 dhcp

To enable debug logs for DHCPv6 relay agent transactions.
Syntax
debug ipv6 dhcp
To disable the debug logs for dhcpv6 relay agent transactions, use the debug
ipv6 dhcp command.
Defaults none
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command-Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
debug ip dhcp client events
Activate the debugging and display of log messages on DHCP client interfaces for IP address acquisition,
IP address release, and IP address and lease time renewal.
Z9500
Syntax
debug ip dhcp client events [interface type slot/port]
Parameters
interface
typeslot/port
704
Description
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Introduced on the C-Series and S-Series.
— displays the contents of the DHCP binding table.
Description
Introduced on the S4810, S4820T, S6000 and Z-Series.
Enter the keyword interface with the interface type and
slot/port information to display DHCP event messages for a
specified interface. The valid interface types are:
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet.
Dynamic Host Configuration Protocol (DHCP)