Fip-Snooping Port-Mode Fcf - Dell Z9500 Command Reference Manual

fip-snooping port-mode fcf

Configure the port for bridge-to-FCF links.
Z9500
Syntax
fip-snooping port-mode fcf
To disable the bridge-to-FCF link on a port, use the no fip-snooping port-
mode fcf command.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
8.3.19.0
8.3.12.0
Usage The maximum number of FCFs supported per FIP snooping-enabled VLAN is four.
Information
fip-snooping max-sessions-per-enodemac
Configure the maximum session limit per ENode MAC address.
Z9500
Syntax
fip-snooping max—sessions—per—enode—mac max-sessions-value
To return the configured maximum sessions to the default value, use the no fip-
snooping max—sessions—per—enode—mac command.
Parameters
max-sessions-
value
Defaults 32
FIP Snooping
Description
Introduced on the Z9500 and S6000-ON.
Introduced on the S4820T.
Introduced on the S4810.
Enter the maximum number of sessions allowed per ENode
MAC address. The range is from 1 to 64.
769