Hardware-Address - Dell Z9500 Command Reference Manual

Parameters
address
low-address
high-address
Defaults none
Command DHCP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0

hardware-address

For manual configurations, specify the client hardware address.
Z9500
Syntax
hardware-address address
Parameters
address
Defaults none
Command DHCP <POOL>
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
710
Enter a single address to be excluded from the pool.
Enter the lowest address in a range of addresses to be
excluded from the pool.
Enter the highest address in a range of addresses to be
excluded from the pool.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Enter the hardware address of the client.
Description
Introduced on the Z9500.
Dynamic Host Configuration Protocol (DHCP)