Renault Laguna III Manual page 2374

MECHANICAL COMPONENT CONTROLS
Clutch pedal: Removal - Refitting
LEFT-HAND DRIVE
II - REFITTING OPERATION FOR PART
CONCERNED
ELECTRONIC PARKING BRAKE
a Refit the clutch pedal position sensor (see 37A, Me-
chanical component controls, Clutch pedal posi-
tion sensor: Removal - Refitting, page 37A-45) .
a Refit:
- the clutch pedal plate spacers,
- the clutch pedal plate.
a Clip the wiring onto the clutch pedal plate.
a Refit the clutch pedal plate nuts.
a Torque tighten the plate nuts (21 N.m).
a Place the clutch cylinder ball joint on the pedal.
ELECTRONIC PARKING BRAKE
a Reconnect the clutch pedal position sensor connec-
tor.
a Refit:
- the clutch end of travel switch (see 37A, Mechani-
cal component controls, Clutch pedal position
sensor: Removal - Refitting, page 37A-45) ,
- the clutch start of travel switch (see 37A, Mechan-
ical component controls, Clutch pedal position
sensor: Removal - Refitting, page 37A-45) .
III - FINAL OPERATION
a Refit:
- the driver's side footwell air distribution duct (see
Front footwell air distribution duct: Removal -
Refitting) (61A, Heating),
- the dashboard lower trim (see Dashboard lower
trim: Removal - Refitting) (57A, Interior equip-
ment).
a Connect the battery (see Battery: Removal - Refit-
ting) (80A, Battery).
37A-40
37A