Renault Laguna III Manual page 2346

MECHANICAL COMPONENT CONTROLS
Brake servo: Removal - Refitting
REFITTING
I - REFITTING PREPARATION OPERATION
a Check the presence and condition of the brake ser-
vo seal (4) .
a Replace the brake servo seal if necessary.
a The shaft of the double safety connecting piece be-
tween the brake servo pushrod and the brake pedal
must be replaced.
a Before refitting, check dimension L :
- 167.3 mm for left-hand drive vehicles,
109206
- 118.5 mm for right-hand drive vehicles.
If the dimension is not correct, replace the brake ser-
vo.
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
- the brake servo,
- the brake servo nuts.
a Torque tighten the brake servo nuts (24 N.m).
a Refit the double safety connecting piece between
the brake servo pushrod and the brake pedal.
a Connect the non-return valve onto the brake servo.
III - FINAL OPERATION
D91, and V4Y , and AJ0
a Refit the left-hand side suspended engine mounting
(see Left-hand suspended engine mounting: Re-
moval - Refitting) (19D, Engine mounting).
a Remove the following tools:
- (Mot. 1852),
- (Mot. 1720),
37A-12
37A
91101-1