Renault Laguna III Manual page 2312

POWER ASSISTED STEERING
Power-assisted steering pipes: Removal - Refitting
F4R, and LEFT-HAND DRIVE – M9R, and 802 or 805, and LEFT-HAND DRIVE
- the clip (6) using the (Mot. 1448).
a Clip on the low pressure pipe at (5) .
a Refit the power-assisted steering pipe bracket bolt
(4) .
a Fit the low pressure pipe clip (3) using the (Mot.
1448).
a Refit:
- the front bumper (see Front bumper: Removal -
Refitting) (MR 416, 55A, Exterior protection),
- the front wheel arch liners (see Front wheel arch
liner: Removal - Refitting) (MR 416, 55A, Exterior
protection),
- the front left-hand wheel (see 35A, Wheels and ty-
res, Wheel: Removal - Refitting, page 35A-1) .
III - FINAL OPERATION.
a Fill the power-assisted steering circuit reservoir (see
Vehicle: Parts and consumables for the repair)
(MR 415, 04B, Consumables - Products).
WARNING
T o prevent damaging the power-assisted steering
system, do not keep the steering at full lock.
a Bleed the power-assisted steering circuit:
- lift the vehicle so that the wheels are off the ground,
- start the engine,
- turn the steering wheel so the wheels lock left then
right (repeat this operation three times).
Note:
Monitor the fluid level in the reservoir during the
power-assisted steering circuit bleed operation.
a Top up the power-assisted steering fluid level if nec-
essary.
a Check that there are no leaks.
a Refit:
- the engine undertray bolts,
- the engine undertray.
36B-33
36B