Renault Laguna III Manual page 2321

POWER ASSISTED STEERING
Power-assisted steering pipes: Removal - Refitting
D91, and V4Y , and LEFT-HAND DRIVE
a Disconnect the pressostat connector (12) .
a Remove the nut (13) for the power-assisted steering
high pressure pipe on the rocker cover.
a Remove:
- the high pressure pipe bolts (14) from the gearbox,
- the power-assisted steering high pressure pipe.
a Fit blanking plugs into all openings.
REFITTING
I - REFITTING PREPARATION OPERATION
a parts always to be replaced: Power-assisted
steering pipe seal (13,04,04,22).
II - REFITTING OPERATION FOR PART
CONCERNED
a
WARNING
Do not remove the blanking plugs from each
component until the last moment.
Also, do not remove the components from their
packaging until they are to be fitted to the vehi-
cle.
1 - Low pressure pipe between the power-assisted
135268
steering pump and the reservoir
a Refit the power-assisted steering low pressure pipe.
a Fit:
- the low pressure pipe clip on the power-assisted
steering pump using the tool (Mot. 1448),
- the clip of the low pressure pipe on the power-as-
sisted steering fluid reservoir using the tool (Mot.
1448).
a Clip the power-assisted steering low pressure pipe
onto the timing cover.
2 - High pressure pipe between the power-assisted
steering pump and the steering box
a Refit:
- the power-assisted steering high pressure pipe,
- the high pressure pipe union on the power-assisted
steering pump.
a Tighten to torque:
- the high pressure pipe union on the power-as-
sisted steering pump (21 N.m),
135267
- the high pressure pipe nut on the rocker cover
(8 N.m),
- the high pressure pipe bolts on the gearbox (8
N.m).
a Refit the power-assisted steering pipe bracket on
the steering box.
a Connect:
- the pressostat connector,
36B-42
36B