Renault Laguna III Manual page 2364

MECHANICAL COMPONENT CONTROLS
Brake pedal switch: Removal - Refitting
REFITTING
I - REFITTING PREPARATION OPERATION
a
WARNING
T o avoid damaging the multifunction switch (3) :
- handle the switch (3) with care,
- only activate the piston (4) during the adjust-
ment phase,
- do not perform more than 3 adjustments to
dimension (X),
- do not separate the piston (4) from the switch
(3) .
Replace the switch (3) :
- if the piston (4) is separated from the switch (3)
- if more than 3 consecutive adjustments to
dimension (X) have been performed.
a Measure dimension (X) of the piston (4) . If the di-
mension (X) is less than 12 mm, carefully pull on the
end of the piston to adjust the dimension (X) to be-
tween a minimum of 12 mm and a maximum of 20
mm.
II - REFITTING OPERATION FOR PART
CONCERNED
a Depress the brake pedal by hand.
a Refit the brake light switch.
a Lock the brake light switch by turning it a quarter of
a turn clockwise.
a Connect the connector.
a Carefully support the return of the brake pedal.
Note:
The brake pedal switch has an automatic adjust-
ment feature, adapting to the pedal position.
The automatic adjustment makes a clicking noise
when in operation.
III - FINAL OPERATION.
a Check that the brake light switch is operating cor-
rectly:
- depress the brake pedal to switch on the lights,
108436
- release the brake pedal to switch off the lights.
LEFT-HAND DRIVE
a Refit the absorbent material.
RIGHT-HAND DRIVE
a Refit the glovebox (see Glovebox: Removal - Refit-
ting) (57A, Interior equipment).
37A-30
37A