Renault Laguna III Manual page 2376

MECHANICAL COMPONENT CONTROLS
Clutch pedal: Removal - Refitting
RIGHT-HAND DRIVE
a Unclip the clutch master cylinder ball joint (8) from
the pedal.
a Remove the clutch pedal plate nuts (9) .
ELECTRONIC PARKING BRAKE
a Disconnect the clutch pedal position sensor connec-
tor.
a Unclip the clutch pedal plate wiring at (10) .
a Remove:
- the clutch pedal plate,
- the clutch pedal plate spacers.
ELECTRONIC PARKING BRAKE
a Remove the clutch pedal position sensor (see 37A,
Mechanical component controls, Clutch pedal
position sensor: Removal - Refitting, page 37A-
45) .
REFITTING
I - REFITTING PREPARATION OPERATION
a Replace the clips if they are damaged.
II - REFITTING OPERATION FOR PART
CONCERNED
ELECTRONIC PARKING BRAKE
a Refit the clutch pedal position sensor (see 37A, Me-
chanical component controls, Clutch pedal posi-
tion sensor: Removal - Refitting, page 37A-45) .
a Refit:
- the clutch pedal plate spacers,
- the clutch pedal plate.
a Clip the wiring onto the clutch pedal plate.
a Refit the clutch pedal plate nuts.
a Torque tighten the clutch pedal plate nuts (21
N.m).
a Place the clutch cylinder ball joint on the pedal.
ELECTRONIC PARKING BRAKE
a Reconnect the clutch pedal position sensor connec-
tor.
a Refit:
- the clutch end of travel switch (see 37A, Mechani-
cal component controls, Clutch pedal position
sensor: Removal - Refitting, page 37A-45) ,
- the clutch start of travel switch (see 37A, Mechan-
ical component controls, Clutch pedal position
sensor: Removal - Refitting, page 37A-45) .
III - FINAL OPERATION
a Refit:
- the dashboard cross member (see Dashboard
cross member: Removal - Refitting) (42A, Upper
front structure),
- the dashboard (see Dashboard: Removal - Refit-
ting) (57A, Interior equipment).
a Connect the battery (see Battery: Removal - Refit-
ting) (80A, Battery).
37A-42
37A