Ospf Cost; Ospf Dr-Priority - 3Com 5500G-EI Command Reference Manual

[SW5500-ospf-1]area 1
[SW5500-ospf-1-area-0.0.0.1]network 131.119.0.0 0.0.255.255
[SW5500-ospf-1-area-0.0.0.1]authentication-mode md5
[SW5500-ospf-1-area-0.0.0.1]quit
[SW5500-ospf-1]quit
[SW5500]interface vlan-interface 1
[SW5500-Vlan-interface1]ospf authentication-mode md5 15 3Com

ospf cost

Syntax
ospf cost
undo ospf cost
View
VLAN Interface view
Parameter
value
Description
Using the
each interface.
Using the
For the Switch 5500-EI, the default cost for running OSPF protocol of on a VLAN
interface is 10.
Example
To specify a cost of 33 when the interface vlan-interface 1 runs OSPF, enter the
following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface vlan-interface 1
[SW5500-Vlan-interface1]ospf cost 33

ospf dr-priority

Syntax
ospf dr-priority
undo ospf dr-priority
View
VLAN Interface view
Parameter
value
from 0 to 255. The default value is 1.
value
Enter the cost for running the OSPF protocol, in the range 1 to 65535.
command, you can configure the cost of sending traffic from
ospf cost
command, you can restore the default costs.
undo ospf cost
value
Enter the interface priority for electing the "designated router", ranging
OSPF Configuration Commands 207