Usb Transmit Hub Address Endpoint N Registers (Usbtxhubaddr[0]- Usbtxhubaddr[15]); Usb Transmit Hub Address Endpoint N Registers (Usbtxhubaddr[N]); Usb Transmit Hub Address Endpoint N Registers(Usbtxhubaddr[N]) Field Descriptions - Texas Instruments Concerto F28M35 Series Technical Reference Manual

Register Descriptions
18.5.23 USB Transmit Hub Address Endpoint n Registers (USBTXHUBADDR[0]-
USBTXHUBADDR[15])
The transmit hub address endpoint n 8-bit read/write registers (USBTXHUBADDR[n]), like
USBTXHUBPORT[n], must be written only when a USB device is connected to transmit endpoint EPn via
a USB 2.0 hub. This register records the address of the USB 2.0 hub through which the target associated
with the endpoint is accessed.
Note: USBTXHUBADDR0 is used for both receive and transmit for endpoint 0.
For the specific offset for each register see
Mode(s): OTG A or Host
The USBTXHUBADDR[n] registers are shown in
Figure 18-28. USB Transmit Hub Address Endpoint n Registers (USBTXHUBADDR[n])
7 6
Reserved
R-0
LEGEND: R/W = Read/Write; -n = value after reset
Table 18-31. USB Transmit Hub Address Endpoint n Registers(USBTXHUBADDR[n])
Bit Field Value
7 Reserved 0
6-0 ADDR 0
1328
M3 Universal Serial Bus (USB) Controller
Table
Field Descriptions
Description
Reserved
Device Address specifies the USB bus address for the target Device.
Copyright © 2012–2019, Texas Instruments Incorporated
18-4.
Figure 18-27 and described in
ADDR
R/W-0
SPRUH22I – April 2012 – Revised November 2019
www.ti.com
Table 18-30.
0
Submit Documentation Feedback