Usb Receive Hub Port Endpoint N Registers (Usbrxhubport[1]-Usbrxhubport[15]); Usb Transmit Hub Port Endpoint N Registers (Usbrxhubport[N]); Usb Transmit Hub Port Endpoint N Registers(Usbrxhubport[N]) Field Descriptions - Texas Instruments Concerto F28M35 Series Technical Reference Manual

Table of Contents

Advertisement

Register Descriptions
18.5.27 USB Receive Hub Port Endpoint n Registers (USBRXHUBPORT[1]-
USBRXHUBPORT[15])
The receive hub port endpoint n 8-bit read/write registers (USBRXHUBPORT[n]), like
USBRXHUBADDR[n], must be written only when a full- or low-speed Device is connected to receive
endpoint EPn via a USB 2.0 hub. Each register records the port of the USB 2.0 hub through which the
target associated with the endpoint is accessed.
Note: USBTXHUBPORT0 is used for both receive and transmit for endpoint 0.
For the specific offset for each register see
Mode(s):
OTG A or Host
The USBRXHUBPORTn registers are shown in
Figure 18-32. USB Transmit Hub Port Endpoint n Registers (USBRXHUBPORT[n])
7
6
Reserved
R-0
LEGEND: R/W = Read/Write; -n = value after reset
Table 18-35. USB Transmit Hub Port Endpoint n Registers(USBRXHUBPORT[n])
Bit
Field
Value
7
Reserved
0
6-0
PORT
0
1332
M3 Universal Serial Bus (USB) Controller
Table
Field Descriptions
Description
Reserved
Hub Port specifies the USB hub port number.
Copyright © 2012–2019, Texas Instruments Incorporated
18-4.
Figure 18-32
and described in
PORT
R/W-0
SPRUH22I – April 2012 – Revised November 2019
www.ti.com
Table
18-35.
0
Submit Documentation Feedback

Advertisement

Table of Contents
loading

Table of Contents