Siemens G130 List Manual page 100

2 Parameters
2.2 List of parameters
r0158[0...n] Voltage Sensing Module firmware version / VSM FW version
VECTOR_G Can be changed: -
Data type: Unsigned32
P-Group: Encoder
Not for motor type: -
Min
-
Description: Displays the firmware version of the Voltage Sensing Module (VSM).
Dependency: Refer to: r0018, r0128, r0197, r0198
Note: Example:
The value 1010100 should be interpreted as V01.01.01.00.
r0158 Terminal Module firmware version / TM FW version
TM31, TM120, TM150, Can be changed: -
TM54F_MA,
Data type: Unsigned32
TM54F_SL
P-Group: Terminals
Not for motor type: -
Min
-
Description: Displays the firmware version of the Terminal Module.
Dependency: Refer to: r0018, r0128, r0148, r0197, r0198
Note: Example:
The value 1010100 should be interpreted as V01.01.01.00.
r0158 DRIVE-CLiQ Hub Module firmware version / Hub FW version
HUB Can be changed: -
Data type: Unsigned32
P-Group: Terminals
Not for motor type: -
Min
-
Description: Displays the firmware version of the DRIVE-CLiQ Hub Module.
p0161 Option board component number / Opt board comp_no
TB30 Can be changed: C1(4)
Data type: Unsigned8
P-Group: Data sets
Not for motor type: -
Min
0
Description: Sets the component number for the option board (e.g. Terminal Board 30).
This unique component number is assigned when parameterizing the topology.
Only component numbers can be entered into this parameter that correspond to an option board.
100
Calculated: -
Dyn. index: p0150
Unit group: -
Scaling: -
Max
-
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
-
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
-
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
199
List Manual (LH2), 07/2016, A5E03263479A
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
Access level: 4
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0
SINAMICS G130/G150