Show Hardware System-Flow - Dell Z9500 Command Reference Manual

OutPort
param2=0(0), param3=0(0)}
{Packets}

show hardware system-flow

Display Layer 3 ACL or QoS data for traffic flows on the central switch (aggregated CoPP) or a specified
line card and port pipe.
Z9500
Syntax
show hardware system-flow layer2 [cp-switch | linecard slot-id
port-set port-pipe]
Parameters
cp-switch
linecard slot-id
portset port-
pipe
Defaults none
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
Usage Use the show hardware system-flow command to display the system flow
Information entries on the central switch (aggregated CoPP) or on a specified set of Z9500
ports. The command output displays statistics on the number of hits for each
system flow.
694
MASK=0x00000001
Offset: 185 Width: 7
DATA=0x00000005
MASK=0x0000007f
action={act=Drop, param0=0(0), param1=0(0),
policer=
statistics={stat id 111
Enter the keyword cp-switch to display information on
system flows of control-plane traffic.
Enter the slot ID and port pipe to display information on
system flows on a specified Z9500 line card and port set.
The range of Z9500 slot IDs is from 0 to 2. The range of
port-pipe numbers is: 0 to 2 on line card 0; 0 to 3 on line
cards 1 and 2.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
slice = 2 idx=4 entries=1}
Debugging and Diagnostics