Multiplier; Protocol Lldp (Configuration) - Dell S4810 Reference Manual

Related

protocol lldp (Configuration)

Commands
show lldp neighbors

multiplier

Set the number of consecutive misses before LLDP declares the interface dead.
S4810
Syntax
multiplier integer
To return to the default, use the no multiplier integer command.
Parameters
integer
Defaults 4 x hello
Command CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
Version 7.4.1.0
protocol lldp (Configuration)
Enable the LLDP globally on the switch.
S4810
Syntax
protocol lldp
To disable LLDP globally on the chassis, use the no protocol lldp command.
Defaults Enabled.
1078
— enables LLDP globally.
— displays the LLDP neighbors.
Enter the number of consecutive misses before the LLDP
declares the interface dead. The range is from 2 to 10.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Link Layer Discovery Protocol (LLDP)