Route Capacity Configuration Commands - 3Com 3031 Command Reference Manual

Route Capacity
Configuration
Commands
display memory limit
Description
Using the route-policy command, you can create and enter route-policy view.
Using the undo route-policy command, you can cancel the established
route-policy.
By default, no route-policy is defined.
Route-policy is used for route information filtering or route policy. One
route-policy comprises of some nodes and each node comprises of some if-match
and apply clauses. The if-match clause defines the match rules of this node and
the apply clause defines the actions after passing the filtering of this node. The
filtering relationship between the if-match clauses of the node is "and", i.e., all
if-match clauses that meet the node. The filtering relation between route-policy
nodes is "OR", i.e. passing the filtering of one node means passing the filtering of
this route-policy. If the information does not pass the filtering of any nodes, it
cannot pass the filtering of this route-policy.
For the related command, see if-match interface, if-match acl, if-match ip-prefix,
if-match ip next-hop, if-match cost, if-match tag, apply ip-address, apply
local-preference, apply cost, apply origin, and apply tag.
Example
Display how to configure one route-policy policy1, whose node number is 10 and
the match mode is permit, and enter route policy view.
[3Com] route-policy policy1 permit node 10
[3Com-route-policy]
Syntax
dispaly memory limit
View
Any view
Parameter
None
Description
Using the display memory limit command, you can view the memory setting and
state information related to the router capacity.
It includes available memory and state information about connections such as
times for disconnecting connections, times for reestablishing connections and
whether the current system is in the emergent state or not.
Example
Display the current memory setting and state information.
<3Com> display memory limit

Route Capacity Configuration Commands

681