3Com 3031 Command Reference Manual page 768

768 C 8: MPLS B C C
HAPTER ASIC ONFIGURATION OMMANDS
Description
Using the static-lsp ingress command, you can configure a static LSP for an ingress
LSR. Using the undo static-lsp ingress command, you can delete an LSP for an
ingress LSR.
This command can be used to configure a static LSP for ingress LSR and
simultaneously set precedence value and metric value for the LSP.
For the related commands, see static-lsp egress, static-lsp transit, and debugging
mpls.
Example
Configure a static LSP for the ingress LSR heading for the destination address
202.25.38.1.
[3Com-mpls] static-lsp ingress bj-sh destination 202.25.38.1 24
nexthop 202.55.25.33 out-label 237
static-lsp transit Syntax
static-lsp transit lsp-name incoming-interface interface-type interface-num
in-label in-label-value { nexthop next-hop-addr | outgoing-interface interface-type
interface-num } out-label out-label-value
undo static-lsp transit lsp-name
View
MPLS view
Parameter
lsp-name: Name of LSP.
interface-type: Type of an incoming or outgoing interface.
Interface-num: Number of an incoming or outgoing interface.
next-hop-addr: Next-hop address.
in-label-value: Value of inbound label, ranging from 16 to 1024.
out-label-value: Value of outbound label, ranging from 16 to 1024.
Description
Using the static-lsp transit command, you can configure a static LSP for transit LSR.
Using the undo static-lsp transit command, you can delete an LSP for transit LSR.
This command can be used to configure a static LSP for transmit LSR.
For the related commands, see static-lsp egress and static-lsp ingress.
Example
Configure a static LSP for the serial interface Serial3/0/0 on transit LSR, with an
inbound label of 123 and an outbound label of 253.