3Com 3031 Command Reference Manual page 482

3com 3031: reference guide

Hide thumbs Also See for 3031:

Table of Contents

undo debugging ipx rtpro-flash

Using the debugging ipx rtpro-flash command, you can turn on the debugging

switch of route refreshing in the IPXRM module. Using the command, you can

turn off the debugging switch of route refreshing in the IPXRM module.

This kind of debugging information is generated when routes are refreshed for the

sake of route change.

Switch on route refreshing debugging for IPXRM module.

<3Com>debugging ipx rtpro-flash

Remove an IPX static route.

[3Com]undo ipx route-static b2 Serial 1

*0.18537610 3Com RMX/8/DBG:

IPXRM set a Rth on the flash list, ulRthDest = 0xb2 .

*0.18537820 3Com RMX/8/DBG:

IPXRM finish a flash, reset a Rth on the flash list, ulRthDest = 0xb2 .

debugging ipx

rtpro-interface

debugging ipx rtpro-interface

undo debugging ipx rtpro-interface

Using the debugging ipx rtpro-interface command, you can turn on the

debugging switch of interface change in the IPXRM module. Using the undo

debugging ipx rtpro-interface command, you can turn off the debugging switch

of interface change in the IPXRM module.

Such debugging information is generated whenever IPXRM module receives

interface change messages. These messages are generated when interface status

changes between up and down, or interface is added or removed.