3Com 3031 Command Reference Manual page 54

3com 3031: reference guide

Hide thumbs Also See for 3031:

Table of Contents

Using the schedule reboot delay command, you can enable the timing reboot

router function and set the waiting time.

By default, the timing reboot router function is disabled.

Two formats can be used to set the waiting delay of timing reboot router, namely

the format of "hour: minute" and the format of "absolute minutes". But the total

minutes should be no more than 30×24×60 minutes, or 30 days.

After this command is configured, the system will prompt you to input

confirmation information. Only after the "Y" or the "y" is entered can the

configuration be valid. If there is related configuration before, it will be covered

Moreover, after the schedule reboot at command is configured, and the system

time is adjusted by the clock command, the original schedule reboot at parameter

will become invalid.

For the related command, see reboot, schedule reboot at, undo schedule reboot,

display schedule reboot.

Configure the router to be restarted after 88 minutes (the current time is 21:32).

<3Com> schedule reboot delay 88

Reboot scheduled for 23:00:00 UTC 2002/11/1 (in 1 hours and 28

Proceed with reboot? [Y/N]:y

upgrade [ bootrom | pico-code] filename

bootrom: Upgrades the BootROM on line .

pico-code: Upgrades the pico-code on line.

filename: The file name of the upgrade software package to be used.

Using the upgrade command, you can upgrade the BootRom program, pico-code

or the logic.