3Com 3031 Command Reference Manual page 837

MPLS TE Configuration Commands 837
View
Explicit path view
Parameter
ip-address: Next IP address along the explicit path
strict: The next hop and local node must be in direct-connect mode.
loose: The next hop and local node can be in the mode other than direct-connect.
Description
Using the next hop command, you can specify next IP address on the explicit path.
Using the undo next hop command, you can delete the IP address specified.
By default, strict is selected.
Example
Specify the next IP address as 10.0.0.1.
[3Com-mpls-te-expl-path-3Com]] next hop 10.0.0.1 loose
tunnel-protocol mpls te Syntax
tunnel-protocol mpls te
View
Tunnel view
Parameter
None
Description
Using the tunnel-protocol mpls te command, you can set the Tunnel interface in
CR-LSP tunnel mode.
When TE is disabled, all tunnel interfaces turns into GRE tunnel mode, in which,
only GRE-related commands are visible and executable. While in CR-LSP tunnel
mode, you can only see and execute CR-LSP-related commands.
The tunnel interface can be in multiple encapsulation types. By default, it is in GRE
point-to-point mode.
For the related commands, see interface tunnel.
Example
Set up a tunnel between Routers Quidway1 and Quidway2, with encapsulation
protocol being mpls te.
[3Com1-Tunnel3] tunnel-protocol mpls te
[3Com2-Tunnel2] tunnel-protocol mpls te
view hop Syntax
view hop [ ip-address ]