3Com 3031 Command Reference Manual page 503

[3Com] ipx service 4 FileServer 130.0000-0a0b-abcd 451 hop 1
preference 60
[3Com] ipx service 4 FileServer 130.0000-0a0b-abcd 451 hop 1
[3Com] ipx service 114 MyServer 199.0000-0a0b-abcd 451 hop 10
Service information with server type 114 will not be advertised if there is no active
route to the network 199.
ipx split-horizon Syntax
ipx split-horizon
undo ipx split-horizon
View
Interface view
Parameter
None
Description
Using the ipx split-horizon command, you can enable split horizon on the current
interface. Using the undo ipx split-horizon command, you can disable split horizon
on the current interface.
By default, split horizon is enabled on the interface.
Split horizon is a way to avoid routing loops, i.e., routing information received
from an interface is not permitted to be sent from the interface. The function does
not take effect to point-to-point connection links.
Example
Enable split horizon on the interface Ethernet1/1/0.
[3Com-Ethernet1/1/0] ipx split-horizon
Disable split horizon on the interface Ehernet1/1/0.
[3Com-Ethernet1/1/0] undo ipx split-horizon
ipx tick Syntax
ipx tick ticks
undo ipx tick
View
Interface view
Parameter
ticks: Delay time in tick, ranging from 0 to 30000. One tick is 1/18 second
(approximately 55 ms). By default, the delay of Ethernet interface is 1 tick, that
of the asynchronous serial port is 30 ticks and that of WAN port is 6 ticks.
IPX Configuration Commands 503