3Com 3031 Command Reference Manual page 735

3com 3031: reference guide

Hide thumbs Also See for 3031:

Table of Contents

MSDP Configuration Commands

peer-address: Address of MSDP peer.

Using the peer request-sa-enable command, you can enable the router to send SA

request message to the specified MSDP peer when receiving a new group join

message. Using the undo peer request-sa-enable command, you can remove the

configuration.

By default, when receiving a new group join message, the router sends no SA

request messages to MSDP peers but waits to receive the next SA message.

For the related command, see cache-sa-enable.

Configure to send SA request message to the MSDP peer 125.10.7.6.

<3Com> system-view

<3Com-msdp] peer 125.10.7.6 request-sa-enable

peer sa-cache-maximum

peer peer-address sa-cache-maximum sa-limit

undo peer peer-address sa-cache-maximum

peer-address: Address of MSDP peer.

sa-limit: Maximum value that the SA cache allows, ranging from 1 to 2048.

Using the peer sa-cache-maximum command, you can limit the number of caches

originated when the router receives SA messages from an MSDP peer. Using the

undo peer sa-cache-maximum command, you can restore the default

configuration.

By default, the maximum number of SA caches is 2048.

This configuration is recommended for all MSDP peers in the networks possibly

attacked by DoS.

For the related commands, see display msdp, sa-count, display msdp peer-status

and display msdp brief.