3Com 3031 Command Reference Manual page 715

display pim neighbor
display pim
routing-table
PIM mode is Sparse
PIM query interval is 30 seconds
Total 1 PIM neighbor on interface
PIM DR(designated router) is 10.10.1.20
Table 2 Description of output information of display pim interface command
Item
PIM is enabled on interface
PIM query interval is 30 seconds
PIM DR (designated router) is 10.10.1.20
Syntax
display pim neighbor [ interface interface-type interface-number ]
View
Any view
Parameter
interface-type interface-number: Interface type and interface number.
Description
Using the display pim neighbor command, you can view the PIM neighbor
information.
Example
Display the PIM neighbor information of the interface Ethernet1/0/0 on the router.
<3Com> display pim neighbor ethernet 1/0/0
Neighbor's Address
10.10.1.10
Syntax
display pim routing-table [ *g [ group-address [ mask { mask-length | mask } ] ] [
incoming-interface { interface-name | null } ] [ dense-mode | sparse-mode ]
display pim routing-table [ **rp [ rp-address [ mask { mask-length | mask } ] ] [
incoming-interface { interface-name | null } ] [ dense-mode | sparse-mode]
display pim routing-table [ source-address [ mask { mask-length | mask } ] [
group-address [ mask { mask-length | mask } ] ] [ incoming-interface {
interface-name | null } ] [ dense-mode | sparse-mode ]
View
Any view
Parameter
**rp: (*, *, RP) route entry.
*g: (*, G) route entry.
group-address: Address of the multicast group.
Description
PIM SM is enabled on the interface Ethernet1/0/0.
The sending interval of Hello message is 30
seconds.
IP address of DR is 10.10.1.20.
Interface Name Uptime
Ethernet1/0/0
PIM Configuration Commands
Expires
00:41:59 00:01:16
715