3Com 3031 Command Reference Manual page 471

display ip policy statistic
Description
Using the display ip policy setup command, you can view the setting information
of policy routings.
The display output of the display ip policy setup local command is the same as that
with policy-tag which will be shown soon, except that it displays the policy routing
enabled on the local router but not the configuration of a certain specified
route-policy.
The display ip policy setup interface command displays the configuration of the
policy routing enabled on the interface.
Example
Display the specific configurations of the specified policy routing, enabled or
disabled.
<3Com> display ip policy setup pr01
route-policy pr01 permit node 0
if-match acl 11
apply ip-address next-hop 3.3.3.3
This command displays the specific configuration of the policy routing named
pr01. As shown above, the policy routing has one 0 node and includes an if-match
clause and an apply clause. For the accurate meanings of the if-match clause and
the apply clause, you can refer to the configuration guide of the command. The
example shows how the option map-tag is used.
Syntax
display ip policy statistic { { policy-tag | local | interface interface-type
interface-number } [ verbose ] }
View
Any view
Parameter
policy-tag: Displays the statistics of the policy identified by policy-tag
performing policy routing process on packets.
local: Displays the statistics of local policy routing packets.
interface: Displays the statistics of interface policy routings.
interface-type: Interface type.
interface-number: Interface number.
verbose: Displays the detailed information.
Description
Using the display ip policy statistic command, you can view the statistics of policy
routings.
Example
Display the matching statistics of the specified policy routing.
<3Com> display ip policy statistic local
local policy pr02 summary information:
IP Unicast Policy Routing Configuration Commands 471