3Com 3031 Command Reference Manual page 175

controller t1
display controller t1
The line code format of CT1/PRI interface defaults to b8zs.
You should keep the line code format of the interface consistent with the one
used by the remote device.
Example
Set the line code format of the interface T1 1/0/0 to ami.
[3com-T1 1/0/0] code ami
Syntax
controller t1 number
View
System view
Parameter
number: The CT1/PRI interface number.
Description
Using the controller t1 command, you can enter a CT1/PRI interface view.
Example
Enter the view of the interface T1 1/00.
[3com]controller t1 1/0/0
[3com-T1 1/0/0]
Syntax
display controller t1 number
View
Any view
Parameter
number: Interface number.
Description
Using the display controller t1 command, you can display the information related
to a CT1/PRI interface. All T1 interfaces will be displayed if no parameter is
selected.
Executing this command will display the following information:
Physical state of interface
Clock mode of interface
Fundamental CT1/PRI Interface Configuration Commands 175