3Com 3031 Command Reference Manual page 651

peer ebgp-max-hop
peer enable
description-line: Description information configured, which can be described in
characters or numerals with the length not exceeding 79.
Description
Using the peer description command, you can configure the description information of the
peer/peer group. Using the undo peer description command, you can remove the
description information of the peer/peer group.
By default, description information of peers/peer group is not configured.
For the related command, see display current-configuration, display bgp peer, and
display bgp routing-table group.
Example
Configure the description information of the peer named group1 as beijing1.
[3Com-bgp] peer group1 description beijing1
Syntax
peer group-name ebgp-max-hop [ ttl ]
undo peer group-name ebgp-max-hop
View
BGP view
Parameter
group-name: Specifies the name of peer group.
ttl: Specifies the maximum hop value. The range is 1 to 255. By default, the
value is 64.
Description
Using the peer ebgp-max-hop command, you can allow establishing EBGP
connection with the peer on indirectly connected network. Using the undo peer
ebgp-max-hop command, you can cancel the existing configuration.
By default, this feature is disabled.
Example
Establish EBGP connection with the peer group "test" on the indirectly connected
network.
[3Com-bgp] peer test ebgp-max-hop
Syntax
peer { group-name | peer-address } enable
undo peer { group-name | peer-address } enable
View
BGP unicast address family view, IPv4 multicast address family view, VPNv4 address
family view, L2VPN address family view
BGP Configuration Commands 651