3Com 3031 Command Reference Manual page 371

3com 3031: reference guide

Hide thumbs Also See for 3031:

Table of Contents

round-robin: Select call channel using cyclic selection policy.

vc-number: Select call channel using the policy of computing available logical

Using the x25 hunt-group command, you can create or enter an X.25 hunt group.

Using the undo x25 hunt-group command, you can delete the specified X.25 hunt

X.25 hunt group supports two call channel selection policies: round-robin mode

and vc-number mode, and a hunt group only uses one channel selection policy.

The round-robin mode will select next interface or XOT channel inside hunt group

for each call request using cyclic selection method. The vc-number mode will

select the interface with the most idle-logical channels in hunt group for each call

A hunt group can have 10 interfaces or XOT channels at most, and it may

nondistinctively select the available channels between interface and XOT channel.

XOT channel cannot join the hunt group that adopts the vc-number selection

For the related command, see display x25 hunt-group.

Create hunt group hg1 which uses cyclic selection policy.

[3Com] x25 hunt-group hg1 round-robin

[3Com-hg-hg1]

called-address

x25 ignore called-address

undo x25 ignore called-address

Interface view

Using the x25 ignore called-address command, you can enable it to ignore the

X.121 address of the called DTE when X.25 initiates calls. Using the undo x25

ignore called-address command, you can disable this function.

By default, this function is disabled.

LAPB and X.25 Configuration Commands