3Com 3031 Command Reference Manual page 823

display mpls te tunnel
running
display mpls te tunnel
statistics
modify hop
Syntax
display mpls te tunnel running tun-num
View
Any view
Parameter
tun-num: Specifies tunnel number.
Description
Using the display mpls te tunnel running command, you can view the information
of active tunnels. Only configuration information of those tunnels where LSP has
been created will be displayed, excluding those for which configuration result has
been submitted, but no LSP has been created.
Example
Display the configuration information of the CR-LSPs created successfully.
[3Com] display mpls te tunnel running 0
Tunnel0
Status: Down
Loop detection: Enable
Record label: Disable
Resv Style: SE
Explicit path: xhy
Tunnel bandwidth: 200(kbps)
Destination: 100.1.1.1
Syntax
display mpls te tunnel statistics
View
Any view
Parameter
None
Description
Using the display mpls te tunnel statistics command, you can view tunnel statistics.
Example
Display MPLS TE tunnel statistics.
[3Com] display mpls te tunnel statistics
Ingress: 1 ( 0 ready, 0 modifying, 1 setuping, 0 failed )
Transit: 0
Egress: 0
Syntax
modify hop ip-address1 ip-address2 [ strict | loose ]
MPLS TE Configuration Commands 823