3Com 3031 Command Reference Manual page 206

206 C 3: I M C
HAPTER NTERFACE ANAGEMENT OMMANDS
Description
Using the cable command, you can configure the cable mode of the ATM T3
cable, to set the distance between the router and the cable distribution frame.
Using the undo cable command, you can restore the default setting.
By default, short distance mode is used.
Example
Set the cable length mode of ATM T3 1/0/0 to long.
<3com> system-view
[3com] interface atm 1/0/0
[3com-Atm1/0/0] cable long
clock Syntax
clock { master | slave }
undo clock
View
ATM E3/T3 interface view.
Parameter
master: Sets the clock mode of ATM E3/T3 to master mode.
slave: Sets the clock mode of ATM E3/T3 to slave mode.
Description
Using the clock command, you can set the clock mode of ATM E3/T3 interface.
Using the undo clock command, you can restore the default setting.
By default, the clock mode of ATM E3/T3 interface is slave mode.
Example
Set clock mode of ATM E3/T3 interface 2/0/0 as master.
<3com> system-view
[3com] interface atm 2/0/0
[3com-Atm2/0/0] clock master
display interface atm Syntax
display interface atm [ interface-number ]
View
Any view