3Com 3031 Command Reference Manual page 747

MBGP Multicast Extension Configuration Commands 747
Example
Enter the IPv4 multicast sub-address family view.
<3Com> system-view
<3Com] bgp 100
<3Com-bgp] ipv4-family multicast
<3Com-bgp-af-mul]
network Syntax
network ip-address [ address-mask ] [ route-policy policy-name ]
undo network ip-address [ address-mask ] [ route-policy policy-name ]
View
IPv4 multicast sub-address family view
Parameter
ip-address: Network address that BGP advertises.
address-mask: Mask of the network address.
route-policy policy-name: Route policy applied to the routes advertised.
Description
Using the network command, you can configure the network addresses to be sent
by the local BGP. Using the undo network command, you can remove the existing
configuration.
By default, the local BGP does not advertise any route.
Example
Advertise routes to the network segment 10.0.0.0/16.
<3Com-bgp-af-mul] network 10.0.0.1 255.255.0.0
peer Syntax
advertise-community
peer { group-name | peer-address } advertise-community
undo peer { group-name | peer-address } advertise-community
View
IPv4 multicast sub-address family view
Parameter
group-name: Name of the peer group.
peer-address: IP address of the peer.
Description
Using the peer advertise-community command, you can configure to advertise
community attributes to a peer (group). Using the undo peer advertise-community
command, you can remove the existing configuration.