3Com 3031 Command Reference Manual page 280

3com 3031: reference guide

Hide thumbs Also See for 3031:

Table of Contents

ISDN interface view

digits: The number of the digits, which is sent each time in overlap-sending mode

and is in the range of 1 to 15.By default, digits are 10.

Using the isdn overlap-sending command, you can set the system to send the

called number information in the overlap mode on the ISDN interface. Using the

undo isdn overlap-sending command, you can set the system to send the called

information in full mode.

In "overlap-sending" mode, the digits of each called number will be sent

separately and the number of the digits sent each time can be set using this

In "full-sending" mode, all the digits of each called number will be collected and

sent at a time.

By default, full-sending mode applies.

You are not allowed to configure this command on an ISDN interface if there is still

a call on it. This command can take effect only if it is configured when there is no

call on the interface. Alternatively, you can manually disable the interface by

executing the shutdown command, configure the command, and then enable the

interface by executing the undo shutdown command. The operations, however,

will lead to the disconnection of the call existing on the interface.

Overlap-sending is only suitable for four ISDN protocols: ANSI, DSS1, ETSI, and NI.

Apply the overlap-sending function on the interface Bri0/0/0 and set the number

of digits allowed to be sent each time to 12 digits.

[3Com-Bri0/0/0] isdn overlap-sending 12

isdn pri-slipwnd-size

isdn pri-slipwnd-size window-size

isdn pri-slipwnd-size default

Interface view

window-size: Slide window size in the range of 5 to 14. By default, the slide

window size on PRI interfaces is 7.