3Com 3031 Command Reference Manual page 386

3com 3031: reference guide

Hide thumbs Also See for 3031:

Table of Contents

x25 switching

Using the x25 switch svc xot command, you can add an X.25 switching route

whose forwarding address is XOT channel. Using the undo x25 switch svc xot

command, you can delete the specified X.25 switching route.

By default, no X.25 switching route is configured.

After configuring the XOT switching command of X.25 SVC, a user can cross IP

network from the local X.25 network to implement the interconnection with the

remote X.25 network. If a user configures the keepalive attribute, the link

detection for XOT will be supported.

Table 24 XOT channel parameter option

timer seconds

source interface-type interface-name

For the related commands, see x25 switch svc interface, display

x25 switch-table svc, and x25 switching.

Switch SVC 1 to the destination address 10.1.1.1.

[3Com] x25 switch svc 1 xot 10.1.1.1

x25 switching

undo x25 switching

Using the x25 switching command, you can enable the X.25 switching function.

Using the undo x25 switching command, you can disable this function, which will

not affect the established VC switching function.

By default, X.25 packet switching function is disabled.

X.25 packet switching is used to accept packets from an X.25 interface and send

them to a certain interface based on the destination information contained in the

packets. The Router can be used as a small-sized packet switch by the packet layer

switching function.

Keepalive timer delay of XOT connection. The timer sends the keepa

detect the connection availability. Its value ranges from 1 to 3600.

Number of maximum retries of sending keepalive. If the number exc

connection will be disconnected. Its value ranges from 3 to 3600.

Interface name of initiating XOT connection