3Com 3031 Command Reference Manual page 695

Multicast Common Configuration Commands 695
undo multicast routing-enable
View
System view
Parameter
None
Description
Using the multicast routing-enable command, you can enable IP multicast routing.
Using the undo multicast routing-enable command, you can disable IP multicast
routing.
By default, IP multicast routing is disabled.
the system will not forward any multicast packet when IP multicast routing is
disabled.
For the related commands, see pim dm and pim sm.
Example
Enable IP multicast routing.
<3Com> system-view
<3Com] multicast routing-enable
reset multicast Syntax
forwarding-table
reset multicast forwarding-table [ statistics ] { all | { group-address [ mask {
group-mask | group-mask-length } ] | source-address [ mask { source-mask |
source-mask-length } ] | { incoming-interface interface-type interface-number } | {
slot slot-number } } * }
View
User view
Parameter
statistics: If this parameter is used, the statistics of MFC forwarding entries will be
cleared. Otherwise, the MFC forwarding entries will be cleared.
all: All the MFC forwarding entries.
group-address: Address of the specified group.
group-mask: Address mask of the specified group.
group-mask-length: Address mask length of the specified group.
source-address: Address of the specified source.
source-mask: Address mask of the specified source.
source-mask-length: Address mask length of the specified source.